1. Pay attention to protecting the nozzle (suction head) during use and do not touch other objects;
2. Please be patient and wait for the machine's response during use, and do not stop at any time to avoid affecting the machine's lifespan.
3. Keep the work environment clean and prevent deviation in results.
4. Be careful when removing the nozzle from the suction head. First, make a rough adjustment. Quickly hang the suction gun onto the nozzle, maintain a distance of 1cm, and then slowly insert the suction gun into the nozzle; (When there is a deviation in the shipping appendix of the position parameter table during operation, it needs to be fine tuned.)
5. When the gun head is used to draw two liquids, it is necessary to replace the gun head to avoid cross contamination;
6. The software is open and supports correction of liquid volume and position. If there is any deviation, numerical changes can be corrected in the settings interface.
7. When setting the position, be sure to start from zero and ensure reset to ensure position accuracy and reproducibility.
8. Not suctioning the rear liquid indicates that no empty suction was performed before suctioning. Please confirm that the air suction action is being executed first.